Bolting the Customer Bucket

There are two sets of holes for mounting—the Base Tray and the Customer Millwork. The hole patterns for the Base Tray and the Customer Millwork are the same.

Note:  The anchors are not shipped with the kiosk and must be obtained locally.

Countertop	Mounting Hole	Recommended Anchors
Wood	Narrow holes (5.8 mm)	Flat–head, #10 wood screws, coarse threads, shorter than countertop thickness.
Non-Wood	Wider holes (6.6 mm)	Flat–head, #1/4–20 threaded screws, as long as needed. Secure with nylon lock nuts and fender washers under the countertop.

1.Mark the location of the anchor holes on the countertop or use the dimensions below.

2.Drill the six holes on the countertop as needed for the anchors being used.

3.Insert the customer millwork base tray into the bucket.

4.Pull out the sliding tray to reveal and locate the mounting holes.

Note:  Make sure that the mounting holes of the millwork, base tray, and countertop are all aligned.

5.Install the six mounting screws to secure the millwork and the base tray to the counter top.